User's Manual

Juno Series User Guide 97
Getting Connected 7
c. Tap Finish on the right softkey.
You are returned to the Connections screen.
You have now configured the dialup networking connection.
Step 2: Connecting to the Internet using the dialup network
1. On the handheld, go to the Connections screen, if it is not already open (tap /
Settings / Connections / Connections).
2. Below My ISP, tap Manage existing connections.
3. Tap and hold the connection you want to use and then select Connect.
4. Unless the phone provider confirmed that you must enter user name, password,
and domain settings to access the Internet, tap
OK on the left softkey without
entering any information in this screen. Otherwise, enter the required
information and then tap
OK on the left softkey.
5. If the phone prompts for confirmation to connect to the Internet, accept the
connection.
The phone dials the configured GPRS access number and then connects to the
Internet.
A Connectivity notification appears on the handheld as the connection is being
made.
After the connection is made you are returned to the My ISP screen.
To confirm that the Juno series handheld is connected to the phone, or to check
the status of the connection at any time, tap the Connectivity icon in the
title bar. The notification shows the name of the current connection, and the
time elapsed since the connection was made. To hide the notification, tap
Hide.
Note – If you have an active wireless LAN connection, the connectivity icon appears as
instead.
6. Tap
OK in the top right corner of the screen to close the My ISP screen.
7. Tap
OK in the top right corner to close the Connections screen.
8. Tap in the top right corner to close the Settings screen.
To check the connection status at any time, tap the or icon in the title bar.
To end the connection at any time, tap the or icon in the title bar and then tap
Disconnect.
To connect to a corporate network or Intranet, see page 104.
To send and receive email messages, see Messaging, page 52.