User's Manual

Juno Series User Guide 91
Getting Connected 7
Step 1: Configuring the connection to the network
1. On the handheld, tap / Settings /
Connections / Connections.
2. Below My ISP, tap Add a new modem connection.
3. Enter the name for the connection.
4. Do one of the following:
• For the Juno SC handheld:
– from the Select a Modem dropdown list,
select Internal Cellular Modem and then tap
Next on the right softkey.
– Enter the GPRS access number for the
Internet.
Two of the common GPRS access numbers for GSM networks are *99***1#
and *99#. If these access numbers do not work, contact the cellular service
provider to obtain the appropriate number to use.
• For the Juno SD handheld:
– from the Select a Modem dropdown list, select Cellular Line (GPRS) and
then tap
Next on the right softkey.
– Enter the required Access point name (APN). A common APN used by a
number of carriers is "internet". If this APN does not work then contact the
cellular service provider to obtain the appropriate APN to use.
5. Tap
Next on the right softkey.
6. Unless the phone provider confirmed that you must enter the user name,
password, and domain settings to access the Internet, tap
Finish on the right
softkey without entering any information on this screen.
Otherwise:
a. Enter the required information.
b. If the service provider has told you that you need to change the baud rate
or other settings for the connection, tap
Advanced, configure these
settings and then tap
OK in the top right corner of the screen.
c. Tap
Finish on the right softkey.
You are returned to the Connections screen.
You have now configured the connection.
Step 2: Connecting to the Internet using the cellular network
1. On the handheld, go to the Connections screen, if it is not already open (tap /
Settings / Connections / Connections).
2. Below My ISP, tap Manage existing connections.