User's Manual

Juno Series User Guide 79
Getting Connected 6
6. Tap OK in the top right corner to close the Connections screen.
7. Tap in the top right corner to close the Settings screen.
To check the connection status at any time, tap the Connectivity icon in the title
bar.
To end the connection at any time, tap the Connectivity icon in the title bar and
then tap
Disconnect.
The Modem Status Indicator in the Today screen indicates the signal strength and
connectivity status within the cellular network. For more information, see page 37.
To connect to a corporate network or Intranet, see page 94.
To send and receive e-mail messages, see Messaging, page 48.
Connecting to a Bluetooth-enabled device
To use another Bluetooth-enabled device with the Juno series handheld, you must
form a Bluetooth connection between the two devices, during which you select the
type of service to use for the connection. This defines how the devices will
communicate with each other.
After forming the Bluetooth connection between the devices you may need to
configure settings for the connection such as the COM port for the field software to
use, or the number for the phone to dial. You must then connect to the other device
using the appropriate software application.
To connect the Juno series handheld to another Bluetooth-enabled device, you can use
either a paired connection or a non-paired connection.
Note – If you are connecting to a phone, skip this section and go to Connecting to a
Bluetooth-enabled phone for Internet access on page 82, where the pairing step is
described as part of the procedure for connecting to a phone.
Trimble recommends using a paired connection, if pairing is supported by the other
device, as a paired connection creates a more secure connection and makes
reconnecting to the device easier. For more information, see Pairing with a Bluetooth-
enabled device below.
Some devices do not support paired connections. Use a non-paired connection if the
device does not have a keyboard, and if you know that the device does not
automatically exchange a pre-programmed passkey during pairing. For more
information, see Setting up a connection to a non-paired device, page 81.
To connect the Juno series handheld to the other device, do one of the following:
• Pair with a Bluetooth-enabled device (see below)
• Set up a connection to a non-paired device (see page 81)