User's Manual

CHAPTER
6
SPSx80 Smart GPS Antenna User Guide 51
Configuring the Receiver Settings 6
In this chapter:
Q Using the SCS900 Site Controller
software to configure the base
station, the rover, and the radios
Q Configuring the receiver to log
data for postprocessing
Q Configuring the receiver in real
time
Q Configuring the receiver using
application files
Q Creating and editing the
configuration files that control
the receiver
You can configure the SPS GPS receiver family in
a variety of ways. This chapter describes the
different configuration methods, and explains
when and why each method is used.
The SPS770 and SPSx80 receivers have no
controls for changing settings. To configure these
receivers:
• In real time, use external software such as
the HYDROpro
™
software, or the GPS
Configurator or WinFlash utility.
• In an application file, use the Configuration
Toolbox utility.
The SCS900 Site Controller software is likely to be
your main tool to set up and operate the receiver
on a daily basis. All necessary field configurations
are handled through the SCS900 software
running on a TSC2 or TCU controller. For more
information, refer to the Trimble SCS900 Site
Controller Software Getting Started Guide or the
Trimble SCS900 Site Controller Software Office
Guide.
The external software detailed in this chapter is
primarily used to update the receiver firmware
and to configure upgrades or radio channels.