User's Manual
Table Of Contents
- USER GUIDE
- Legal Notices
- Safety Information
- Contents
- Introduction
- Features and Functions
- Batteries and Power
- Setup Guidelines
- Setting up the Receiver
- Configuring the Receiver Settings
- Using the SCS900 Site Controller software to configure the base station, the rover, and the radios
- Configuring the receiver to log data for postprocessing
- Configuring the receiver in real time
- Configuring the receiver using application files
- Creating and editing the configuration files that control the receiver
- AutoBase Feature
- Default Settings
- Specifications
- NMEA-0183 Output
- GSOF Messages
- Adding Internal Radio Frequencies
- Upgrading the Receiver Firmware
- Data Logging and Postprocessed Measurement Operations
- Troubleshooting
- Glossary
2 Features and Functions
22 SPSx80 Smart GPS Antenna User Guide
LED flash patterns
The following table details the possible flash patterns to indicate various states of
receiver operation.
Note – If a column shows “N/A”, that specific LED may or may not be on, but it is not
relevant to that particular mode.
Receiver mode Power LED
Green
Radio LED
Green
Satellite LED
Amber
Receiver OFF OFF OFF OFF
Receiver ON
Healthy power ON N/A N/A
Low power Fast flash N/A N/A
Tracking <4 SVs ON N/A Fast flash
Tracking >4 SVs ON N/A Slow flash
Logging data internally Flashes off every
3 seconds
N/A N/A
Receiving valid data packets ON Slow flash N/A
No data packets ON OFF N/A
Monitor mode ON Slow flash ON