User's Manual
Table Of Contents
- GeoExplorer® 6000 series
- Legal Notices
- Safety Information
- Contents
- Introduction
- Getting Started
- Using the Windows Mobile Operating System
- Connecting to an Office Computer
- Using the GNSS Receiver
- Supported GNSS field software
- Configuring the GNSS field software to connect to the receiver
- Using the GNSS field software
- Improving GNSS productivity using Floodlight satellite shadow reduction technology
- Ensuring the accuracy of your GNSS data
- Activating the Floodlight technology and the NMEA output options
- Differential GNSS explained
- Outputting NMEA data to external equipment
- Configuring NMEA output
- Getting Connected
- Wireless connection information
- Connecting to a cellular network from the modem
- Connecting to a Wi-Fi access point
- Connecting to a Bluetooth-enabled device
- Connecting to a Bluetooth device as a client
- Providing Bluetooth services as a host
- Setting up a Bluetooth connection
- Connecting to a Bluetooth-enabled phone for Internet access or real-time corrections (including VRS networks)
- Connecting to the Internet through a Bluetooth-enabled phone using the Bluetooth PAN profile
- Connecting to a Bluetooth-enabled serial device
- Connecting to an office computer using Bluetooth wireless technology
- Outputting GNSS data to other devices using Bluetooth wireless technology
- Enabling other devices to transfer files using Bluetooth wireless technology
- Beaming files to or from another device
- Accessing a corporate network through your Internet connection
- Connecting to other devices using the USB to serial converter
- Using the Camera
- Troubleshooting
GeoExplorer 6000 Series User Guide 27
Getting Started 2
– Use the battery only in Trimble equipment that is specified to use it.
– Use the battery only for its intended use and according to the instructions in the product
documentation.
Inserting the battery
To insert the battery into the handheld:
1. Slide the battery into the cavity with the label facing upwards (as shown in
Figure 2.3).
2. Push the battery in until it clicks into place.
C
CAUTION – Make sure that the battery is fully inserted and that both the left and right
latches are fully engaged. If the battery is not properly inserted, it may fall out if the
device is dropped.
Figure 2.3 Inserting the battery
Note – Charge the battery completely before using the handheld for the first time. If the
battery has been stored for longer than six months, charge it before use. Trimble
recommends charging the battery for five hours to recharge it fully.
Charging the battery
Charge the battery in the handheld, or, if you have a spare battery, you can charge it
outside the handheld.
To charge the battery:
1. Connect one end of the AC adaptor cable to the battery and the other to an AC
power outlet. An international adaptor kit is provided with the handheld.
2. Turn off the handheld or put the handheld in Suspend mode (see page 31).
Note – Trimble recommends that you charge the handheld at or below normal room
temperature (0 to 30 °C / 32 to 86 °F ).