User's Manual
Table Of Contents
- GeoExplorer® 2005 Series Getting Started Guide
- Legal Notices
- Safety Information
- About this Manual
- System Components
- Getting Started
- Windows Mobile Basics
- ActiveSync Connections
- Installing Software
- Using GPS
- Power
- Memory
- Internet and Network Connections
- Using the Bluetooth Radio
- Using the WLAN Radio
- Using Cabled Ethernet
- Using the Optional Serial Clip
- Personalizing your Handheld
- Use and Care
- Troubleshooting
- Index
Memory
GeoExplorer 2005 Series Getting Started Guide 41
Note – Do not store data to an SD memory card that you will require if
the card is removed, for example an application. Data saved to an SD
memory card is only available when the card is inserted in the
handheld.
To insert an SD memory card:
Place the handheld on a dust-free indoor surface.
C
WARNING – The presence of any dust or moisture in the SD slot may
adversely affect the device and void your Trimble warranty. To prevent
dust or moisture entering the SD slot:
- Make certain that the SD door is attached correctly when you are
using the handheld outdoors.
- When inserting or removing an SD card, place the handheld on a
dust-free indoor surface.
1. Unscrew the stylus cap to access the screwdriver.
2. Use the screwdriver to undo both screws on the SD door.
3. Insert the SD memory card into the SD slot.
Note – The GeoExplorer 2005 series handheld does not support SDIO
(SD input/output) cards.
4. Reattach the SD door, insert both screws and tighten. Ensure that
it is attached correctly.
5. Replace the stylus cap.
To remove an SD memory card:
1. Remove the SD door (see steps 1 to 2 above).
2. To eject the SD card from the SD card slot, push the card in.
screwdriver
cap
SD card