User's Manual

Power
38 GeoExplorer 2005 Series Getting Started Guide
Suspend mode
When you press the Power button to turn off the handheld, the
handheld goes into Suspend mode. This is a low-power mode that
maintains the main memory contents but does not allow you to
operate any of the handheld’s functions. The handheld appears to be
turned off. The integrated GPS receiver is turned off and any
application using GPS is disconnected.
To turn on the handheld when it is in Suspend mode, press the
Power button. The handheld is ready for operation. There may be a
delay of up to 30 seconds while the integrated GPS receiver
automatically reactivates.
You can configure the handheld to automatically enter Suspend
mode when it has been idle for a specified time. By default, the
handheld is set to enter Suspend mode if the handheld is not used for
three minutes.
To change the time to enter Suspend mode:
1. Tap / Settings / System / Power.
2. Tap the Advanced tab.
3. From the On battery power group,
select the Turn off device if not used
for check box and select the idle time
from the drop-down list.
4. Tap
OK.