User's Manual

Power
GeoExplorer 2005 Series Getting Started Guide 35
AC adaptor safety
C
WARNING – To use AC adaptors safely:
- Use only the AC adaptor intended for the GeoExplorer 2005 series
handheld. Using any other AC adaptor can damage your product
and may void your warranty. Do not use the AC adaptor with any
other product.
- Make certain that the input voltage on the adaptor matches the
voltage and frequency in your location.
- Make certain that the adaptor has prongs compatible with your
outlets.
- AC adaptors are designed for indoor use only. Avoid using the AC
adaptor in wet outdoor areas.
- Unplug the AC adaptor from power when not in use.
- Do not short the output connector.
- There are no user-serviceable parts in this product.
- Should damage to the AC adaptor occur, replace it with a new Trimble
AC adaptor (P/N 61234-00).
Charging the internal Lithium-ion battery
The rechargeable Lithium-ion battery is supplied partially charged.
Charge the battery completely before using it for the first time. If the
battery has been stored for longer than six months, charge it before
use. Trimble recommends charging the battery for eight hours to
recharge it fully.
An international adaptor kit is provided with the GeoExplorer 2005
series handheld. To charge the handheld’s internal battery, use the
international adaptor kit connected to either the support module or
the optional serial clip.
Note – The GeoExplorer 2005 series handheld is not compatible with the
AC adaptor or support module supplied with previous versions of the
handheld (and vice versa). You must use the AC power adaptor
(P/N 61234-00) and support module (P/N 53500-00) provided with the
GeoExplorer 2005 series handheld.