User's Manual
Table Of Contents
- GeoExplorer® 2005 Series Getting Started Guide
- Legal Notices
- Safety Information
- About this Manual
- System Components
- Getting Started
- Windows Mobile Basics
- ActiveSync Connections
- Installing Software
- Using GPS
- Power
- Memory
- Internet and Network Connections
- Using the Bluetooth Radio
- Using the WLAN Radio
- Using Cabled Ethernet
- Using the Optional Serial Clip
- Personalizing your Handheld
- Use and Care
- Troubleshooting
- Index
34 GeoExplorer 2005 Series Getting Started Guide
Power 9
When fully charged, the internal battery of the handheld provides
enough power for a full working day using GPS. To extend the time
between charges, use the optional vehicle power adaptor
(P/N 61235-00) or the external power kit (P/N 57123-00). Use the
support module with the AC adaptor (P/N 61234-00) supplied with
the international adaptor kit to recharge the internal battery.
Safety warnings
Battery safety
C
WARNING – The GeoExplorer 2005 series handheld is powered by an
internal rechargable Lithium-ion battery. Charge and use the battery
only in strict accordance with the instructions provided.
To prevent injury or damage:
- Never attempt to remove, replace, or repair the battery yourself.
- Do not damage the battery.
- Do not store or leave your device near a heat source such as near a
fireplace or other heat-generating appliance, or otherwise expose it
to temperatures in excess of 70°C (158°F) such as on a vehicle
dashboard. When heated to excessive temperatures, battery cells
could explode or vent, posing a risk of fire.
- Do not use the handheld if the battery appears to be leaking.
- If the battery requires attention, send the handheld to your local
Trimble Service center.
- Discharge the handheld before disposing of the battery. When
disposing of the battery, be sure to do so in an environmentally
sensitive manner. Adhere to any local and national regulations
concerning battery disposal or recycling.