User's Manual

used to extend range.
Frequency range 902–928 MHz 2
Networks 40 user selectable networks
Transmit power Meets FCC requirements of 1 W maximum
power output
Wireless data rates 128 kbps
Modes Base/Repeater/Rover
900 MHz
Range
Optimal 10 km (6 miles), line-of-sight
Typical 3–5 km (2–3 miles) Varies with terrain and
operating conditions. Repeaters may be
used to extend range.
Frequency range 902–928 MHz 2
Networks 40 user selectable networks
Transmit power Meets FCC requirements of 1 W maximum
power output
Wireless data rates 128 kbps
Modes Base/Repeater/Rover
2400 MHz
Range
Optimal 10 km (6 miles), line-of-sight
Typical 3–5 km (2–3 miles) Varies with terrain and
operating conditions. Repeaters may be
used to extend range.
Frequency range 902–928 MHz 2
Networks 40 user selectable networks
Transmit power Meets FCC requirements of 1 W maximum
power output
Wireless data rates 128 kbps
Modes Base/Repeater/Rover
1 Power consumption, as well as the permissible number of repeaters in a network,
depends on the information content and wireless data rate (that is, CMR vs RTCM SC-
104 Ver. 2.x packets at 1 Hz epoch rates).
2 Broadcast frequency and radiated power are regulated by countries-of-use. These are
unique on a per country basis. The broadcast frequencies, and country-of-use for the
radio-modem must be specified at time of order.
Pinout Information
Figure A.1 shows the pinout information for the 8-pin male Bendix connector on the base
of the AQUA radio-modem.
Figure A.1 AQUA connector (8-pin Mil-Spec)