User's Manual

Diagnostics and Firmware Upgrade
Use WinFlash to download a diagnostics file from the AQUA to an office computer or to
upgrade the radio firmware. These options are available in the WinFlash Operation
Selection window. For firmware upgrades, contact your Trimble dealer. The dealer will
supply a new software file to perform the upgrade.
Installing the AQUA
Introduction
It is recommended that you read this chapter before installing your Aqua radio.
Physical Description
The Aqua radio-modem is encased in a rugged, waterproof metal case. It has an antenna
mounts on the top, a connector on the bottom and a LED on the front . The physical
aspects of Aqua hardware are outlined below, followed by details covering interface
connections and antenna installations.
Connectors and Indicators
The Aqua radio is fitted with an 8-pin male Bendix connector and an LED indicator light.
See Figure 4.1.
Figure 4.1 AQUA Connectors
The LED can be orange and/or green depending on the situation, as shown in Table 4.1.
Note – The top cap of the AQUA has an antenna contact tip. The tip is designed for
maximum efficiency and very low loss. Please take care not to damage this tip. Keep the
low-profile antenna or flexible antenna base screwed on to the top of the radio when
storing the AQUA, see page 32.
Table 4.1 Operational Status
LED Color Status
LED Off No Power
LED On Solid Radio has power
No communication w/ base station
LED Flashing (1Hz) Radio has power
Communication w/ base station