User's Manual

used to extend range.
Frequency range 902–928 MHz2
Networks 40 user selectable networks
Transmit power Meets FCC requirements of 1 W maximum
power output
Wireless data rates 128 kbps
Modes Base/Repeater/Rover
900 MHz
Range
Optimal 10 km (6 miles), line-of-sight
Typical 3–5 km (2–3 miles) Varies with terrain and
operating conditions. Repeaters may be
used to extend range.
Frequency range 902–928 MHz2
Networks 40 user selectable networks
Transmit power Meets FCC requirements of 1 W maximum
power output
Wireless data rates 128 kbps
Modes Base/Repeater/Rover
2400 MHz
Range
Optimal 10 km (6 miles), line-of-sight
Typical 3–5 km (2–3 miles) Varies with terrain and
operating conditions. Repeaters may be
used to extend range.
Frequency range 902–928 MHz2
Networks 40 user selectable networks
Transmit power Meets FCC requirements of 1 W maximum
power output
Wireless data rates 128 kbps
Modes Base/Repeater/Rover
1 Power consumption, as well as the permissible number of repeaters in a network,
depends on the information content and wireless data rate (that is, CMR vs RTCM SC-
104 Ver. 2.x packets at 1 Hz epoch rates).
2 Broadcast frequency and radiated power are regulated by countries-of-use. These are
unique on a per country basis. The broadcast frequencies, and country-of-use for the
radio-modem must be specified at time of order.
Pinout Information
Figure A.1 shows the pinout information for the 8-pin male Bendix connector on the base
of the AQUA radio-modem.
Figure A.1 AQUA connector (8-pin Mil-Spec)