User Manual
Table Of Contents
- Trimble R6, R7 GPS Receivers / Trimble R8 GNSS Receiver User Guide
- Legal notices
- Safety Information
- Contents
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R6 GPS R8 GNS Receivers
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes: Trimble R6/R7 GPS Receivers Trimble R8 GNSS Receiver
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
CHAPTER
10
Trimble R6/R7 GPS and Trimble R8 GNSS Receivers User Guide 65
Cables and Connectors 10
In this chapter:
Q Port 1, 2, and 3 connectors
Q Power/serial data cable
Q Event marker/1PPS cable
Q GPS antennas and cables
This chapter provides pinout information for the
Trimble R7 GPS receiver standard and optional
cables. This information can be used to build
special cables for connecting the receiver to
devices and instruments not supported by the
standard and optional cables.