User Manual
Table Of Contents
- Trimble R6, R7 GPS Receivers / Trimble R8 GNSS Receiver User Guide
- Legal notices
- Safety Information
- Contents
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R6 GPS R8 GNS Receivers
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes: Trimble R6/R7 GPS Receivers Trimble R8 GNSS Receiver
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
Trimble R6/R7 GPS and Trimble R8 GNSS Receivers User Guide v
Safety Information
C
WARNING – Formatting a CompactFlash card while it is in the receiver deletes all the data
files on the card and all the application files in the receiver.
C
WARNING – Upgrading the firmware deletes all application files on the receiver.
C
WARNING – Operating or storing the receiver outside the specified temperature range
can damage it. For more information, see Chapter 8, Specifications and Chapter 17,
Specifications.
C
WARNING – The receiver allows a maximum of 200 files on the internal memory. The
filenames must be in 8.3 format, otherwise, files copied to the internal memory may cause
data corruption or loss of data when logging.
Data is logged using the current logging settings configured in the receiver. Data files
logged internally are named automatically.