User Manual
Table Of Contents
- Trimble R6, R7 GPS Receivers / Trimble R8 GNSS Receiver User Guide
- Legal notices
- Safety Information
- Contents
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R6 GPS R8 GNS Receivers
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes: Trimble R6/R7 GPS Receivers Trimble R8 GNSS Receiver
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
CHAPTER
18
Trimble R6/R7 GPS and Trimble R8 GNSS Receivers User Guide 115
Default Settings 18
In this chapter:
Q Default settings
Q Resetting to factory defaults
All receiver settings are stored in application files.
The default application file is stored permanently
in the receiver, and contains the factory default
settings for the receiver. whenever the receiver is
reset to its factory defaults, the current settings
(stored in the current application file are reset to
the values in the default application file.
You cannot modify the default application file.
However, if there is a power up application file
(Power_up) in the receiver, the settings in this file
can be applied immediately after the default
application file, overriding the factory defaults.
For more information, see Application files,
page 98.