User Manual
Table Of Contents
- Trimble R6, R7 GPS Receivers / Trimble R8 GNSS Receiver User Guide
- Legal notices
- Safety Information
- Contents
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R6 GPS R8 GNS Receivers
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes: Trimble R6/R7 GPS Receivers Trimble R8 GNSS Receiver
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
16 Software Utilities
110 Trimble R6/R7 GPS and Trimble R8 GNSS Receivers User Guide
Trimble R6 GPS and R8 GNSS Receiver Operation
Updating the frequency list
You can program the internal transceiver modem with a list of up to 20 frequencies,
which are stored in non-volatile memory. This list is pre-configured based on the
frequencies that you requested when you ordered the unit. Government regulations
stipulate that only manufacturers or authorized dealers can create this frequency list
and that all frequencies programmed into a unit must comply with the host country
regulations. If you need to add, delete, or replace frequencies, contact your Trimble
dealer, and provide the radio modem serial number and an updated list of the
frequencies you require. Once you receive the frequency file, you can upgrade the radio
using the WinFlash utility.