User Manual
Table Of Contents
- Trimble R6, R7 GPS Receivers / Trimble R8 GNSS Receiver User Guide
- Legal notices
- Safety Information
- Contents
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R6 GPS R8 GNS Receivers
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes: Trimble R6/R7 GPS Receivers Trimble R8 GNSS Receiver
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
13 Setting up the Receiver
86 Trimble R6/R7 GPS and Trimble R8 GNSS Receivers User Guide
Trimble R6 GPS and R8 GNSS Receiver Operation
Figure 13.3 Receiver pole-mounted setup
13.1Other system components
This section describes optional components that you can use with the receiver.
131.1 Radios
Radios are the most common data link for Real-Time Kinematic (RTK) surveying. The
receiver is available with an optional internal radio in the 450 MHz UHF band, or with
an internal GSM module. You can also connect an external radio to either receiver
port, whether or not the internal radio is installed.
F
F
TrimbleR6GPS/R8GNSSreceiver
ACU controller