User's Manual
Table Of Contents
- USER GUIDE
- Legal Notices
- Safety Information
- Contents
- Introduction
- Features and Functions
- Batteries and Power
- Setup Guidelines
- Setting up the Receiver
- Configuring the Receiver Settings
- Using the SCS900 Site Controller software to configure the base station, the rover, and the radios
- Configuring the receiver to log data for postprocessing
- Configuring the receiver in real time
- Configuring the receiver using application files
- Creating and editing the configuration files that control the receiver
- AutoBase Feature
- Default Settings
- Specifications
- NMEA-0183 Output
- GSOF Messages
- Adding Internal Radio Frequencies
- Real-Time Data and Services
- Upgrading the Receiver Firmware
- Data Logging and Postprocessed Measurement Operations
- Troubleshooting
- Glossary
APPENDIX
B
SPSx80 and SPSx81 Smart GPS Antennas User Guide 97
GSOF Messages B
In this appendix:
Q
Supported message types
Q General Serial Output Format
Q Reading binary values
Q GSOF message definitions
This appendix provides information on the
General Serial Output Format (GSOF) messages.
GSOF messages are a Trimble proprietary format
and can be used to send information such as
position and status to a third-party device.
For information on how to output GSOF
messages, see Chapter 7, Configuring the
Receiver Settings
.