User's Manual
Table Of Contents
- USER GUIDE
- Legal Notices
- Safety Information
- Contents
- Introduction
- Features and Functions
- Batteries and Power
- Setup Guidelines
- Setting up the Receiver
- Configuring the Receiver Settings
- Using the SCS900 Site Controller software to configure the base station, the rover, and the radios
- Configuring the receiver to log data for postprocessing
- Configuring the receiver in real time
- Configuring the receiver using application files
- Creating and editing the configuration files that control the receiver
- AutoBase Feature
- Default Settings
- Specifications
- NMEA-0183 Output
- GSOF Messages
- Adding Internal Radio Frequencies
- Real-Time Data and Services
- Upgrading the Receiver Firmware
- Data Logging and Postprocessed Measurement Operations
- Troubleshooting
- Glossary
5 Setting up the Receiver
50 SPSx80 and SPSx81 Smart GPS Antennas User Guide
For rod-based operation, mount the SPSx80 or SPSx81 Smart GPS antenna as follows:
1. Mount the receiver on the top of the rod using the 5/8"×11 thread in the base of
the SPSx80 or SPSx81.
2. Insert the controller into the controller bracket.
3. The SPSx80 or SPSx81 and controller communicates through Bluetooth wireless
technology. However, if a cable is required, connect the cable between the
controller and receiver (see
Figure 5.6
through Figure 5.7).
Figure 5.6 Connections for a rover SPSx81 setup, a TSC2 or TCU controller, and a 450 MHz base station
Figure 5.7 Cabled connections for an SPSx81 setup, a TSC2 or TCU controller, and a 900 MHz base
station (with external power)
Cabled connections Bluetooth connections
P/N 53002007
P/N 59046
P/N 53002007
P/N 59046
P/N 59049-02
P/N 46125-20
P/N
70012-00