User's Manual

ManualsBrandsTrimble ManualsElectronicsGNSS RX with Bluetooth and Spread Spectrum Radio

Table Of Contents

USER GUIDE
Legal Notices
Safety Information
- Regulations and safety
- Type approval
- Exposure to radio frequency radiation
- Installing antennas
- Battery safety
Contents
Introduction
- About the SPSx80 Smart GPS antenna
- About the SPSx81 Smart GPS antenna
- Related Information
- Technical Support
- Your Comments
Features and Functions
- Overview
- SPS780 Smart GPS antenna features
- SPS781 Smart GPS antenna standard features
- SPS880 Extreme Smart GPS antenna standard features
- SPS881 Extreme Smart GPS antenna standard features
- Use and care
- COCOM limits
- Parts of the receiver
  - Front panel
  - Lower housing
- Button functions
- LED behavior
  - LED flash patterns
Batteries and Power
- External power
- Battery safety
- Battery performance
- Charging the Lithium-ion batteries
- Storing the Lithium-ion battery
- Disposing of the rechargeable Lithium-ion battery
Setup Guidelines
- Base station operation guidelines
  - Base station components
  - Base station setup guidelines
- Rover operation guidelines
  - Rover receiver components
  - Rover receiver setup guidelines
- Cellular modem and external radio
Setting up the Receiver
- Connecting the receiver to external devices
  - Trimble controller with SCS900 Site Controller software
  - External radio-modems
- Common ways to set up a base station
- Common ways to set up a rover receiver
Configuring the Receiver Settings
- Using the SCS900 Site Controller software to configure the base station, the rover, and the radios
- Configuring the receiver to log data for postprocessing
- Configuring the receiver in real time
- Configuring the receiver using application files
- Creating and editing the configuration files that control the receiver
AutoBase Feature
- Setting Up a Base Station
  - Best practice
  - Antenna type
- Scenarios
- AutoBase process
Default Settings
- Default receiver settings
- Resetting the receiver to factory defaults
- Default behavior
- Power up settings
- Logging data
  - Logging data after a power loss
Specifications
- General specifications
- Physical specifications
- Electrical specifications
- Communication specifications
- GPS satellite signal tracking
- Integrated radio options
- Variable configuration options
NMEA-0183 Output
- NMEA-0183 message overview
- Common message elements
  - Message values
- NMEA messages
- ADV
- GGA
- GSA
- GST
- GSV
- HDT
- PTNL,AVR
- PTNL,GGK
- PTNL,PJK
- PTNL,VGK
- PTNL,VHD
- RMC
- ROT
- VTG
- ZDA
GSOF Messages
- Supported message types
- General Serial Output Format
- Reading binary values
  - INTEGER data types
- GSOF message definitions
Adding Internal Radio Frequencies
- Adding receive frequencies for the 450 MHz internal radio
Real-Time Data and Services
- RT17 Streamed Data service
- Login authentication
Upgrading the Receiver Firmware
- The WinFlash utility
  - Installing the WinFlash utility
- Upgrading the receiver firmware
Data Logging and Postprocessed Measurement Operations
- Connecting to the office computer
- Transferring files directly from a CompactFlash card
- Deleting files in the receiver
- Supported file types
Troubleshooting
- LED conditions
- Receiver issues
- Base station setup and static measurement problems
Glossary

2 Features and Functions

20 SPSx80 and SPSx81 Smart GPS Antennas User Guide

Figure 2.2 Front panel

The power button controls the receiver’s power on or off functions.

The indicator LEDs show the status of power, satellite tracking, and radio reception.

For more information, see

LED behavior, page 22.

Satellite LED

Radio LED

Power LED

Power button