User's Manual
Table Of Contents
- USER GUIDE
- Legal Notices
- Safety Information
- Contents
- Introduction
- Features and Functions
- Batteries and Power
- Setup Guidelines
- Setting up the Receiver
- Configuring the Receiver Settings
- Using the SCS900 Site Controller software to configure the base station, the rover, and the radios
- Configuring the receiver to log data for postprocessing
- Configuring the receiver in real time
- Configuring the receiver using application files
- Creating and editing the configuration files that control the receiver
- AutoBase Feature
- Default Settings
- Specifications
- NMEA-0183 Output
- GSOF Messages
- Adding Internal Radio Frequencies
- Real-Time Data and Services
- Upgrading the Receiver Firmware
- Data Logging and Postprocessed Measurement Operations
- Troubleshooting
- Glossary
SPSx80 and SPSx81 Smart GPS Antennas User Guide 121
Data Logging and Postprocessed Measurement Operations F
• Use the Data Transfer utility
• With the SPSx50 or SPSx51 Modular GPS receiver, use the Web interface.
Supported file types
Table F. 1 shows the file types that you can transfer to or from a SPS GPS receiver, and
the software or utility that you must use to transfer each file type.
Table F.1 Supported file types
File Type Extensions Transfer
from
receiver
Transfer to
receiver
Software
Ephemeris .eph Yes No Data Transfer
Raw observations .T01, .dat Yes No Data Transfer
Web interface
(SPSx50/SPSx51)
Receiver firmware files .elf No Yes WinFlash utility
Application files
(SPSx80 Smart GPS
antenna)
.cfg Yes Yes GPS Configurator
Configuration
Toolbox