User's Manual
Table Of Contents
- USER GUIDE
- Legal Notices
- Safety Information
- Contents
- Introduction
- Features and Functions
- Batteries and Power
- Setup Guidelines
- Setting up the Receiver
- Configuring the Receiver Settings
- Using the SCS900 Site Controller software to configure the base station, the rover, and the radios
- Configuring the receiver to log data for postprocessing
- Configuring the receiver in real time
- Configuring the receiver using application files
- Creating and editing the configuration files that control the receiver
- AutoBase Feature
- Default Settings
- Specifications
- NMEA-0183 Output
- GSOF Messages
- Adding Internal Radio Frequencies
- Real-Time Data and Services
- Upgrading the Receiver Firmware
- Data Logging and Postprocessed Measurement Operations
- Troubleshooting
- Glossary
APPENDIX
F
SPSx80 and SPSx81 Smart GPS Antennas User Guide 119
Data Logging and Postprocessed
Measurement Operations
F
In this appendix:
Q
Connecting to the office
computer
Q Transferring files directly from a
CompactFlash card
Q Deleting files in the receiver
Q Supported file types
By default, the SPS GPS receivers cannot log data
unless you purchase the Data Logging option.
A Smart GPS antenna uses the internal memory
of the receiver to store this data. The data files
cannot be processed until you transfer them to
your office computer.
Note – The SPS780 Max has an available memory
of 2 MB. The SPS880 Extreme has an available
memory of 6 MB. The SPS781 and SPS881 Extreme
have a maximum of 11 MB memory. None of the
receivers have a maximum file quantity limit.