User's Manual
Table Of Contents
- USER GUIDE
- Legal Notices
- Safety Information
- Contents
- Introduction
- Features and Functions
- Batteries and Power
- Setup Guidelines
- Setting up the Receiver
- Configuring the Receiver Settings
- Using the SCS900 Site Controller software to configure the base station, the rover, and the radios
- Configuring the receiver to log data for postprocessing
- Configuring the receiver in real time
- Configuring the receiver using application files
- Creating and editing the configuration files that control the receiver
- AutoBase Feature
- Default Settings
- Specifications
- NMEA-0183 Output
- GSOF Messages
- Adding Internal Radio Frequencies
- Real-Time Data and Services
- Upgrading the Receiver Firmware
- Data Logging and Postprocessed Measurement Operations
- Troubleshooting
- Glossary
APPENDIX
D
SPSx50 and SPSx51 Modular GPS Receivers User Guide 113
Real-Time Data and Services D
In this appendix:
Q
RT17 Streamed Data service
Q Login authentication
The real-time Binary Output option (also known
as RT17 messages or raw data) is available as an
optional upgrade. The RT17 Streamed Data
service is available only with the SPS780 Max,
SPS781 Max, SPS880 Extreme, and the SPS881
Extreme GPS receivers.
By default, the Binary Output option is not
enabled in the GPS receivers. The option must be
enabled before RT17 messages can be streamed
from the receiver. To enable the option, please
contact your local Trimble dealer.