User's Manual
Table Of Contents
- USER GUIDE
- Legal Notices
- Safety Information
- Contents
- Introduction
- Features and Functions
- Batteries and Power
- Setup Guidelines
- Setting up the Receiver
- Configuring the Receiver Settings
- Using the SCS900 Site Controller software to configure the base station, the rover, and the radios
- Configuring the receiver to log data for postprocessing
- Configuring the receiver in real time
- Configuring the receiver using application files
- Creating and editing the configuration files that control the receiver
- AutoBase Feature
- Default Settings
- Specifications
- NMEA-0183 Output
- GSOF Messages
- Adding Internal Radio Frequencies
- Real-Time Data and Services
- Upgrading the Receiver Firmware
- Data Logging and Postprocessed Measurement Operations
- Troubleshooting
- Glossary
APPENDIX
C
SPSx80 and SPSx81 Smart GPS Antennas User Guide 111
Adding Internal Radio Frequencies C
In this appendix:
Q
Adding receive frequencies for
the 450 MHz internal radio
If you have installed the optional internal
450 MHz radio in your GPS receiver, use the
WinFlash utility to add the relevant receive
frequencies to the default list of frequencies. To
install the WinFlash utility, see
Installing the
WinFlash utility, page 116
.
If you have also purchased the transmit option,
Trimble must specify and configure the
(FCC-approved) transmit broadcast frequencies
at the factory. You cannot configure these
yourself.