User's Manual

CHAPTER
7
SPSx50 Modular GPS Receiver User Guide 75
Configuring the Receiver Settings 7
In this chapter:
Q Using the SCS900 Site Controller
software to configure the base
station, rover, and the radios
Q Configuring the receiver to log
data for postprocessing
Q Configuring Ethernet Settings
Q Configuring the SPSx50 Receiver
Using a Web Browser
You can configure the SPS GPS receiver family in
a variety of ways. This appendix describes the
different configuration methods, and explains
when and why each method is used.
The SCS900 Site Controller software is likely to be
your main tool to set up and operate the receiver
on a daily basis. For more information, refer to
the Trimble SCS900 Site Controller Software
Getting Started Guide or the Trimble SCS900 Site
Controller Software Office Guide.
The external software detailed in this appendix is
primarily used to update the receiver firmware
and to configure upgrades or radio channels. All
necessary field configurations are handled
through the SCS900 software running on a
TSC2
™
or TCU controller.