User Manual

6. Press the appropriate manual axis alignment button to align the laser
plane to the receiver. The clockwise axis alignment button rotates the
laser clockwise; the counterclockwise axis alignment button rotates the
laser counterclockwise.
7. Press and hold the axis alignment button until you get an on-grade
reading on the receiver.
Radio Remote Control (One-Way and Two-Way)
The radio remote control is a hand-held device that allows you to send
operational commands to the laser from a remote location. These operational
commands include changing grade values, rotation speed, and operating
modes. The radio remote control HAS to be used for the following advanced
alignment features:
• Automatic Axis Alignment
• Grade Reverse
• Grade Matching
• PlaneLok
See your operator’s manual for detailed setup and operation of these
advanced features.
A solid “T” symbol appears in the right corner of the LCD to indicate that
the link between the radio remote control and laser is complete. A flashing
bar above the “T” indicates that communication with the laser is established.
When the radio remote control is connected to a receiver, an “R” appears in
the right corner of the radio remote control’s first display line indicating that
a connection has been made and the power is on.
When using the radio remote control, make sure its antenna is pointing
skyward.
Turning On/Off the Radio Remote Control
1. Press the power button to turn on the radio remote control.
Note: When the two-way radio remote control is initially turned on, the axes
symbols and last-entered grade for each axis briefly appear in the LCD.
2. To turn off the radio remote control, press and hold the power button
for 3 seconds.