User Manual

EMC Declaration of Conformity
This laser has been tested and found to comply with the limits for a Class B
digital device for radio noise for digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of Communication, and
is pursuant to part 15 of the Federal Communication Commission (FCC)
rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This laser generates radio
frequency. If it's not used in accordance with the instructions, it may cause
harmful interference to radio or television reception. Such interference can be
determined by turning the laser off and on. You are encouraged to try
eliminating the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the laser and the receiver.
For more information, consult your dealer or an experienced radio/television
technician.
CAUTION: Changes or modifications to the laser that are not expressly
approved by Trimble could void authority to use the equipment.
Application of Council Directive(s): 89/336/EEC
Manufacturer’s Name: Trimble
Manufacturer’s Address: 5475 Kellenburger Road
Dayton, Ohio 45424-1099 U.S.A.
European Representative Address: Trimble Engineering and
Construction S GmbH
Am Prime Parc 11
D-65479 Raunheim, Germany
Model Number(s): GL7XX
Conformance to Directive(s): EC Directive 89/336/EEC using
EN55022 and EN50082-1
Equipment Type/Environment: ITE/residential, commercial & light
industrial
Product Standards: Product meets the limit B and
methods of EN55022
Product meets the levels and
methods of