User Manual

Troubleshooting
If none of the following techniques corrects the problem, take your system to
a local Trimble dealer or authorized service center for evaluation or repair.
Laser
Problem Solution
Laser will not turn on
• Make sure the batteries have
sufficient power and are installed
correctly.
• Make sure the batteries contacts
are in proper working condition.
No signal is received at the receiver
• Make sure the receiver is turned
on.
• Make sure the batteries have
sufficient power and are installed
correctly.
• Make sure the laser is sending out
a beam.
• Check for a laser signal with
another receiver.
No laser beam
• Make sure the laser is on.
• Make sure the batteries have
sufficient power and are installed
correctly.
• Make sure that the laser is within
its self-leveling range (up to
25%).
• Switch the laser into manual
mode; the laser should come on.
The battery life is short
• Make sure high-quality batteries
are being used.
• When recharging the batteries,
make sure the charger is plugged
into an appropriate ac outlet. The
batteries require a minimum
charge time of six hours.