User Manual

Laser Safety
The IEC and the United States Government Center of Devices for Radiology
Health (CDRH) has classified this laser as a Class I laser product (standard
model) and Class II product (long-range model).
Operation
For detailed installation and operating instructions, follow the instructions
given in this manual for this laser. The maximum radiant power output of this
laser is less than 5 mW.
Controls
Controls are listed in the operation section of this manual.
CAUTION: Use of controls or adjustments performance of procedures other
than those specified herein may result in higher dosage of laser exposure.
This laser complies with all applicable portions of Title 21 of the code of
Federal Regulations, Department of Health and Human Services, Food and
Drug Administration (Federal Register, Volume 50, Number 161, August 20,
1985).
Protective Eyewear
This laser complies with OSHA Standards Act Section 1518.54 for use
without eye protection devices. Consequently, protective eyewear is neither
required nor recommended.
As with any visible laser device, the following safety rules should be
observed:
• Never look directly into a laser beam or point the beam into the eyes of
others. Set the laser at a height that prevents the beam from shining
directly into people’s eyes.
• Do not remove any warning signs from the laser.
• Use of this product by people other than those trained on this product
may result in exposure to hazardous laser light.
• If initial service is required, which results in the removal of the outer
protective cover, removal must only be performed by factory-trained
personnel.