User Manual

Connecting the Remote Holster to a Grade Rod
1. Wrap the mounting strap around the grade rod and fasten it securely in
place.
Connecting the Radio Remote Control to the Remote Holster
1. Slip the radio remote control mounting clip into the mounting slot of the
remote holster.
Setting Up the Laser System
Setting Up the Laser in Manual Mode
1. Press the manual mode button on the laser or radio remote control.
Note: When manual mode is activated, the laser’s status LED flashes red at a
1-Hz rate and scrolling horizontal segments appear in the laser’s LCDs. If
you are using a two-way radio remote control, this information also appears
in the radio remote control’s LCD.
2. To adjust the laser in the ∠ axis so that the laser beam matches the
desired slope, use the up and down buttons on the laser or radio remote
control.
3. To adjust the laser in the ∠ axis so that the laser beam matches the
desired slope, use the up and down buttons on the laser or the left and
right buttons on the radio remote control.
4. To resume automatic self-leveling mode, press the manual button on the
laser or radio remote control again.
Aligning the Axis Manually
The manual axis alignment buttons are primarily used on lasers that don’t
have radio remote control capability. These buttons rotate the grade axis
electronically (simulates turning the laser on its tripod, with fine adjustment
capability up to a maximum of ±40 degrees).
1. Set up the laser over a reference point. Make sure the laser is positioned
so that the ∠ and ∠ axes are pointing in the right direction.
2. Using the sighting guides as guide, rotate the laser on its tripod to align the
laser to the direction hub.