User Manual

remote control, this information also appears in the radio remote control’s
LCD.
Note: When the grade value for either axis reaches its highest amount, the
grade values switches to the lowest value for that axis. In the ∠ axis, for
example, the value switches from +10.00% to –10.00%. In the ∠ axis, the
value switches from 25.00% to –0.500%. For steep-grade lasers than value
switches from 110.0% to –0.500%.
Note: All changes to the axis-alignment rotation made prior to changing the
grade value using the quick-change method will be cancelled out.
Activating/Deactivating Manual Mode
Manual mode bypasses the laser’s automatic self-leveling mode so you can
use the laser in vertical mode. Manual mode also allows you to tilt the laser
beyond its built-in sloping capability so you can perform steep-sloping
horizontal applications.
1. Press the manual mode button.
Note: When manual mode is activated, the laser’s status LED flashes red
once per second and scrolling horizontal segments appear in the laser’s
LCDs. If you are using a two-way radio remote control, “Manual Mode”
appears in the radio remote control’s LCD.
2. To resume automatic self-leveling mode, press the manual mode button
again.
Activating Automatic-Axis-Alignment, Grade-Matching, and PlaneLok
Modes
Note: For more detailed information about these modes, please see the
System Setup section of this manual.
1. Select the desired mode from the operational mode menu using the mode
button.
2. Select the axis (∠ or ∠) that you are aligning using the radio remote
control’s up or down buttons.
3. Press the enter button to confirm the selection.
Note: While the system is aligning, “Start” followed by “Wait” appears in the
radio remote control’s LCD.
4. When the alignment has been completed, “Complete” appears in the radio
remote control’s LCD.
Note: Alignment can take one to five minutes to complete.