User Manual

Off On Recharging is in progress
Flashing Off Recharging is complete
Flashing Flashing Recharging error
Note: The laser will not operate while the batteries are recharging.
Note: Some countries or local areas have regulations regarding the disposal
of rechargeable batteries. Please be sure to follow the regulation in your area.
Installing/Removing the Batteries
CAUTION: The batteries should be removed when storing the laser more
than 30 days.
1. Remove the four screws from the battery housing. Remove the battery-
housing compartment.
2. Install/remove the batteries.
Note: When installing the batteries, be sure to note the positive (+) and
negative (-) diagram inside of the housing.
Note: The laser has reverse polarity protection. If the batteries are put in
wrong, no damage occurs to the laser but it does not work. Allow it one
minute to recover after the batteries have been installed correctly.
3. Put the battery-housing compartment in place and reinstall the four
screws.
External Power Cable
The laser system also includes an external power cable so you can operate
the laser in case the internal batteries become discharged. The internal
batteries will not recharge, however, while you’re using the external power
cable.
Connecting/Disconnecting the External Power Cable
CAUTION: To avoid damaging the laser, make sure the laser is off before
connecting/disconnecting the external power cable to/from the laser.
1. Connect the alligator clips to a 12-V dc automotive or motorcycle
battery noting the correct polarity (red = positive, black = negative).
2. Plug the 4-socket plug into the laser and tighten the retaining collar.
3. To disconnect the external power cable from the laser, loosen the
retaining collar, unplug the 4-socket plug from the laser, and remove the
alligator clips from the battery.