User's Guide

What's in the box
● EDB10 data bridge
● USB-C Charging/Firmware cable
● A/C Adapter and International connectors
● Module screwdriver
● Quick Start Guide
Charging Battery
1. Connect the USB Charging cable to the AC adapter, and plug into power.
2. Plug in the EDB10 to the charging cable
3. Charge for six hours or until fully charged.
Connecting EDB10 to an EMPOWER module
1. Before connecting an EDB10 to an Empower Module, please ensure the EDB10 is powered off. Powering
on the EDB10 prior to connecting an Empower module may lead to an ability to connect to an instrument,
and will require a reset of the EDB10.
2. To connect, align the units together (as shown below) with the Empower Module slightly higher than the
EDB10, and slide the Empower module down so the top lip of the Empower module hooks neatly over the
top of the EDB10. The bottom of the Empower Module will fit neatly into the cavity of the EDB10 with the
bottom edge lying flush against the recess of the EDB10.