Quick Start Guide

3
Standard camera mount
screw hole
Battery (covered)
USB-C charging port
(covered by access panel)
Rear view
BUTTON BEHAVIOR
The EDB10 data bridge has two
buttons located on the side of the unit.
Use the Power button to:
• Power On/O the EDB10 data bridge. Short Press (1 second)
• Perform a soft reset; Long Press (9 Seconds)
• Perform a hardware reset = Long Press (13 seconds)
• View the battery status = <1 second “button tap”
The Action (Module) button is designed to work with the
EMPOWER module when it is attached to the EDB10 data bridge.
• With the EM120 module, reset the module = Long Press (>10
seconds).
4