Operation Manual

Table Of Contents

SiteNet 450 Operation Manual 23

Installing the SiteNet 450 Network 3

2. Securely mount the adapter plate to the machine. Do one of the

following:

– Use existing weld bosses (see Figure 3.4)

– Weld some weld bosses to the cab

– Clamp the plate to the top of a handrail at the top of the cab

using the U-bolts

3. Bolt the radio mounting bracket to the adapter plate using the

rubber shock mount kit. The bolts are included with the adapter

plate.

Tip – Use threadlocking Loctite (PN 33803) or equivalent to secure the

bolts when you assemble the shock mounts.

Figure 3.4 shows a SiteNet 450 mounted at the rear of a cab roof.

Notice how this installation ensures that all of the antenna is above the

cab’s roof.

****NEW PHOTO FROM Joan Hollerich GOES

HERE********THIS ONE SHOWS A 900*******

SN450.book Page 23 Friday, October 5, 2001 5:01 PM