User's Manual

Acutime 2000 Synchronization Kit User Guide 6-23
6 NTP Software Installation and Configuration
6.6.3 Starting the Service
The last steps are performed using the Services Applet in the
Windows NT Control panel.
1. Open the Control Panel Services Applet.
2. Scroll to Network Time Protocol.
3. Make sure Startup is set to
Automatic.
4. Click
Start.
NTP starts and the Network Time Protocol service status changes to
Started. Close the Services Applet.
Manual NTP configuration is complete. NTP will start each time the
system is booted. To verify the correct operation of NTP and the
Acutime NTP reference clock, follow the instructions in
Monitoring NTP, page 6-31.