User's Manual Part 2

2
XDL Micro Intergrator’s Guide
Contact Information
Customer support and sales contacts
Quality, technology, and service are the hallmarks of Paci c Crest. We
provide easy access to our customer service department to keep you
running e ciently.
Headquarters EMEA Offi ce
Paci c Crest HAL Trade Center
510 DeGuigne Drive Bevelandseweg 150
Sunnyvale, CA 94085 1703 AX Heerhugowaard
U.S.A  e Netherlands
Tel: [phone] (U.S.A toll free) Tel: [phone]
[phone] (outside the U.S.A) Fax: [phone]
Fax: [phone]
Sales email: sales@Paci cCrest.com
Support email: support@Paci cCrest.com
Repair info: pccservice@Paci cCrest.com
Web www.Paci cCrest.com
Support hours are 8 am to 5 pm Paci c Time. Please visit our website for
up-to-date news and product announcements. Firmware and software
upgrades are available from our website, usually free of charge.
Legal notices
© 2012 Paci c Crest. All rights reserved. Adaptation, or translation of
this manual is prohibited without prior written permission of Paci c
Crest, except as allowed under the copyright laws.  is document
contains proprietary information that is protected by copyright. All
rights reserved.  e information contained in this document is subject
to change without notice.
PORON is a licensed trademark of Rogers Corporation. SATEL is a
registered trademark of SATEL Oy. Trimble is a trademark of Trimble
Navigation Limited, registered in the United States and in other
countries. TRIMMARK and TRIMTALK are trademarks of Trimble
Navigation Limited. Microsoft, Windows, and Windows Vista are either
registered trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries. All trademarks are the property
of their respective owners.
Release notice
 is is the March 2012 release of the XDL Micro Integrator’s Guide.
Warranty
PACIFIC CREST MAKES NO WARRANTY OF ANY KIND WITH REGARD
TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. Paci c Crest shall not be liable for errors contained herein or
for incidental consequential damages in connection with the furnishing,
performance, or use of this material.
Warranty
One-Year limited warranty
 is warranty gives you speci c legal rights. You may also have other
rights which vary from state to state or area to area.
Paci c Crest warrants XDL family products, inclusive of cables and
batteries, against defects in materials and workmanship for a period of
one year from receipt by the end-user.
Exclusions
Should Paci c Crest be unable to repair or replace the product within a
reasonable amount of time, a refund of the purchase price may be given
upon return of the product.
 e warranty on your radio shall not apply to defects resulting from:
• Improper or inadequate maintenance by the customer
• Unauthorized modi cation, negligence, or misuse
• Operation outside of the environment speci cations
Warranty limitations
 is warranty set forth above is exclusive and no other warranty,
whether written or oral, is expressed or implied. Paci c Crest speci cally
disclaims the implied warranties of merchantability and  tness for a
particular purpose.
Notices
Class B Statement – Notice to Users.  is equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules.  ese limits are designed to provide reasonable
protection against harmful interference in a residential installation.
 is equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communication. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit di erent from
that to which the receiver is connected.
• Consult the dealer or Paci c Crest directly for help.
Changes and modi cations not expressly approved by the manufacturer
or registrant of this equipment can void your authority to operate this
equipment under Federal Communications Commission rules.
Canada
 is digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de Classe B
prescrites dans le règlement sur le brouillage radioélectrique édicté par
le ministère des Communications du Canada.
Europe
 is product has been tested and found to comply with the requirements
for a Class B device pursuant to European Council Directive 1999/5/
EC on R&TTE, thereby satisfying the requirements for CE Marking and
sale within the European Economic Area (EEA).  ese requirements are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential or commercial
environment, and to ensure that the equipment is safe.
Australia and New Zealand
 is product conforms with the regulatory requirements of the
Australian Communications and Media Authority (ACMA)
EMC framework, thus satisfying the requirements for C-Tick
Marking and sale within Australia and New Zealand.
Notice to Our European Union Customers
For product recycling instructions and more information,
please go to www.trimble.com/ev.shtml.
Recycling in Europe: To recycle Trimble WEEE (Waste
Electrical and Electronic Equipment, products that run on electrical
power.), Call [phone], and ask for the “WEEE Associate”. Or,
mail a request for recycling instructions to:
Trimble Europe BV
c/o Menlo Worldwide Logistics
Meerheide 45
5521 DZ Eersel, NL
Compliance
 e XDL Micro is designed to be compliant with worldwide regulatory
requirements, including FCC part 90, ETS 300-113-2, IC RSS 119 and
others.
WARNING – The XDL Micro is classified as an intentional
radiator of type radio. Conducted and radiated emissions of
the standard XDL Micro do not exceed the requirements of
FCC part 90 and ETS 300-113-2. OEM is responsible for full
compliance of final product.