User's Manual Part 2

XDL Micro Intergrator’s Guide

Protocols and Operation Modes

You can completely configure the transceiver using the XDLCONF software. Configuration

parameters define the DTE interface and the over-the-air protocol. Depending on your

application, you may need to change the factory default settings.

The following table shows the factory default settings of the transceiver.

Setting Default setting

Channel 1

Baud Rate 38400

Parity None

Soft Break Disable Off

TX Power 0.5 W

Mode Transparent EOT Timeout

Link Rate 9600 bps GMSK

EOT 50 ms

Repeater Delay 0

CSMA On (CSMA is required to be on only in the U.S.A. You should turn off

CSMA in the European Union.)

FEC On

Scrambling On

Sensitivity High

Local Address 0

Destination address 255

Up to 32 frequencies are stored in the configuration memory called the channel table. The

selection of channels is subject to correct licensing of the corresponding frequencies by

the appropriate governmental agency. For instructions in creating and uploading channel

tables into the transceiver, refer to the XDLCONF User’s Guide.

The transceiver supports multiple protocols and modes of operation including:

• Transparent with EOT Timeout

• Transparent with EOT Character

• TRIMTALK II/IIe

• TRIMTALK 450S

• TRIMMARK 3

• SATEL

• South

• Stonex Type 1

• Transparent FST