User's Manual

9 Default Settings
84 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 GPS Receiver Operation
However, when you turn off the receiver using [P], the receiver behaves
as if you pressed [D] to stop logging before you pressed [P]. In this case,
when power is restored normally, logging does not begin until you start
it manually.
93.4 Disabling logging
To disable logging, you can set the receiver’s data logging and position
logging rates to Off. However, if you press [D] while logging is disabled,
the receiver will still log data, using the default logging settings.
93.5 Application files
You can use application files to change the settings in the receiver.
Sending an application file to the receiver does not necessarily apply
the file’s settings; you can apply a file’s settings at any time after sending
it to the receiver. You can also define timed application files. A timed
application file contains receiver settings, but also includes a date and
time when it is automatically activated.
If there is a timed application file on the Trimble R7 receiver, the
receiver automatically applies the file’s settings and begins logging (if
logging settings are included in the file) at the specified time. If the
When the receiver is logging
data and then loses power …
then when
power is
restored, data
logging …
and logging
settings are …
and all other
settings are …
unexpectedly resumes
automatically
the last settings
used
the last settings
used
when you press
[P] does not resume the factory
defaults
the last settings
used
When you have disabled logging … then if you press [D] to start logging,
logging settings are …
using the Trimble Survey Controller or GPS
Configurator software
the factory defaults
in the Power Up application file the factory defaults