User's Manual

Trimble R7/R8 GPS Receiver User Guide 83
Default Settings 9
Trimble R7 GPS Receiver Operation
93.2 Power up settings
When you turn the receiver off, any changes that you have made to
logging settings are lost and these settings are returned to the factory
defaults. Other settings remain as defined in the Current file. The next
time you turn on the receiver, the receiver checks for a power up file
and, if one is present, applies the settings in this file.
93.3 Logging after power loss
If the Trimble R7 receiver loses power unexpectedly, when power is
restored the receiver tries to return to the state it was in immediately
before the power loss. The receiver does not reset itself to defaults or
apply any Power Up settings. If the receiver was logging when power
was lost unexpectedly, it resumes logging when power is restored.
When you use [P] to turn the receiver
off then on again and …
then logging
settings are …
and all other
settings are …
you changed the receiver settings by
applying an application file
the factory defaults the last settings used
you changed the receiver settings using
configuration software
the factory defaults the last settings used
there is a Power Up application file in the
receiver
the factory defaults,
or those in the Power
Up file
a
a
A factory default setting is used only if the setting is not defined in the Power Up file.
the last settings used, or
those in the Power Up
file
a