User's Manual

9 Default Settings
82 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 GPS Receiver Operation
9.2 Resetting to Factory Defaults
To reset the receiver to its factory defaults, do one of the following:
• On the receiver, press and hold down [P] for 15 seconds.
• In the GPS Configurator software, select Connect to Receiver and
then click
Reset receiver in the General tab.
9.3 Examples
The following examples show how the Trimble R7 receiver uses the
default settings and special application files in various situations.
93.1 Default behavior
The factory defaults are applied whenever you start the receiver. If a
Power Up file is present in the receiver, its settings are applied
immediately after the default settings, so you can use a Power Up file to
define your own set of defaults.
When you turn the receiver on
and …
then logging settings
are …
and logging …
it is the first time that the receiver has
been used
the factory defaults does not begin
automatically
you have reset the receiver to its factory
defaults
the factory defaults, or those
in the Power Up file
a
a
A factory default setting is only used if the setting is not defined in the Power Up file.
does not begin
automatically
you have performed a full reset the factory defaults, because
resetting deletes any Power
Up file
does not begin
automatically