User's Manual
Table Of Contents
- Safety Information
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R8 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes Trimble R7 / Trimble R8
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
7 Software Utilities
72 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 GPS Receiver Operation
The Frequency Selection dialog appears:
6. In the Wireless Format group, select the appropriate channel and
wireless mode. The Wireless Mode must be the same for all radios
in your network.
7. In the Specify Frequency field, enter the frequency you require.
8. Click
Add. The new frequency appears in the Selected
Frequencies list.
Note – The frequencies that you program must conform to the channel
spacing and minimum tuning requirements for the radio. To view this
information, click
Radio Info. You may select either 12.5 or 25 kHz
channel spacing. All radios in your network must use the same channel
spacing.
9. When you have configured all the frequencies you require, click
OK. The WinFlash software updates the receiver radio
frequencies and then restarts the receiver.