User's Manual

Trimble R7/R8 GPS Receiver User Guide 71
Software Utilities 7
Trimble R7 GPS Receiver Operation
7. If all is correct, click Finish.
Based on the selections shown above, the Software Upgrade
window appears and shows the status of the operation (for
example,
Establishing communication with the Trimble R7.
Please wait
.).
8. Click
OK.
The Software Upgrade window appears again and states that the
operation was completed successfully.
9. Click
Menu to select another operation, or click Exit to quit
WinFlash.
10. If you click
Exit, another screen appears asking you to confirm
that you want to quit. Click
OK.
70.1 Adding frequencies for the 450 MHz internal radio
If your receiver has the optional internal radio installed, you can use the
WinFlash software to add receiving frequencies to the default list.
1. Start the WinFlash software. The Device Configuration dialog
appears.
2. From the Device type list, select Trimble R7 Receiver.
3. From the PC serial port field, select the serial (COM) port on the
computer that the receiver is connected to.
4. Click
Next.
The Operation Selection screen appears. The Operations list
shows all of the supported operations for the selected device. A
description of the selected operation is shown in the Description
field.
5. Select Configure Radio and then click
Next.