User's Manual
Table Of Contents
- Safety Information
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R8 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes Trimble R7 / Trimble R8
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
6 Transferring Data
62 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 GPS Receiver Operation
Figure 6.2 Connecting the Trimble R7 receiver to a computer for USB
data transfer
Note – When the receiver is connected to a USB port on a computer, it is
treated as a peripheral device of the computer. If the receiver is unplugged
or turned off, a warning message appears on the computer.
6.2 Transferring Data
Transfer the data files to the computer using the Trimble Data Transfer
utility. You can run this utility as a standalone program or from within
the Trimble Geomatics Office software. For more information, refer to
the Data Transfer Help.
USB cable
USB port
USB port