User's Manual
Table Of Contents
- Safety Information
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R8 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes Trimble R7 / Trimble R8
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
3 Setting up the Receiver
34 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 GPS Receiver Operation
Figure 3.13 shows the components required to connect a cellphone to a
Trimble R7 receiver.
Figure 3.13 Connecting a cellphone
For more information on using a cellular modem as a data link, refer to
the Trimble Survey Controller User Guide.
30.2 Antennas
The Trimble R7 receiver should normally be used with a Zephyr or
Zephyr Geodetic antenna, which have been designed specifically for
use with this receiver.
Serial cable
DB9 to Lemo cable