User's Manual

SOFTWARE, AND ACCOMPANYING DOCUMENTATION
AND MATERIALS, (INCLUDING, WITHOUT LIMITATION,
DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS
INTERRUPTION, LOSS OF BUSINESS INFORMATION, OR
ANY OTHER PECUNIARY LOSS), REGARDLESS OF
WHETHER TRIMBLE HAS BEEN ADVISED OF THE
POSSIBILITY OF ANY SUCH LOSS AND REGARDLESS OF THE
COURSE OF DEALING WHICH DEVELOPS OR HAS
DEVELOPED BETWEEN YOU AND TRIMBLE. BECAUSE
SOME STATES AND JURISDICTIONS DO NOT ALLOW THE
EXCLUSION OR LIMITATION OF LIABILITY FOR
CONSEQUENTIAL OR INCIDENTAL DAMAGES, THE ABOVE
LIMITATION MAY NOT APPLY TO YOU.
Regulations and Safety
The Bluetooth module inside your receiver is a radio-modem
transmitter and receiver.
Regulations regarding the use of the radio-modems vary
greatly from country to country. In some countries, the unit
can be used without obtaining an end-user license. Other
countries require end-user licensing. Consult your local
communications governing agency for licensing information.
Before operating this receiver, determine if authorization or a
license to operate the unit is required in your country. It is
the responsibility of the end user to obtain an operator’s
permit or license for this receiver radio-modem for the
location or country of use.
STATEMENT ACCORDING FCC PART 15.19
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
STATEMENT ACCORDING FCC PART 15.21
Modifications not expressly approved by Trimble could void
the user's authority to operate the equipment.
STATEMENT ACCORDING FCC PART 15.105
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician
for help.
Type Approval
Type approval, or acceptance, covers technical parameters of
the equipment related to emissions that can cause
interference. Type approval is granted to the manufacturer of
the transmission equipment, independent from the operation
or licensing of the units. Some countries have unique
technical requirements for operation in particular radio-
modem frequency bands. To comply with those
requirements, Trimble may have modified your equipment
to be granted Type approval. Unauthorized modification of
the units voids the Type approval, the warranty, and the
operational license of the equipment.
Safety
EXPOSURE TO RADIO FREQUENCY RADIATION
You must maintain a minimum separation distance of 20 cm
(approximately 8 in.) between yourself and the radiating
GSM antenna for this device to satisfy the RF Exposure
requirements of the FCC.
For mobile operation, the maximum gain of the GSM
antenna must not exceed 0 dBi.