User's Manual

Trimble R7/R8 GPS Receiver User Guide 153
Default Settings 18
Trimble R8 GPS Receiver Operation
18.2Resetting to Factory Defaults
To reset the Trimble R8 receiver to its factory defaults, do one of the
following:
• On the receiver, press and hold down [P] for 15 seconds.
• In the GPS Configurator software, select Connect to Receiver and
then click
Reset receiver in the General tab.
182.1 Default behavior
The factory defaults specified above are applied whenever you start the
receiver. If a power up file is present in the receiver, its settings are
applied immediately after the default settings, so you can use a power
up file to define your own set of defaults.
Input Setup: Station Any
NMEA/ASCII (all messages) All Ports Off
Streamed output All Types Off
Offset = 00
RT17/Binary All Ports Off
Reference position: Latitude 0°
Longitude 0°
Altitude 0.00 m HAE
Antenna: Type Trimble R8/5800 Internal
Height (true vertical) 0.00 m
Group All
Measurement method Bottom of mount
Table 18.1 Default settings (continued)
Function Factory default