User's Manual

18 Default Settings
152 Trimble R7/R8 GPS Receiver User Guide
Trimble R8 GPS Receiver Operation
All Trimble R8 receiver settings are stored in application files. The
default application file is stored permanently in the receiver, and
contains the factory default settings for the receiver. whenever the
receiver is reset to its factory defaults, the current settings (stored in the
current application file are reset to the values in the default application
file.
You cannot modify the default application file. However, if there is a
power up application file (power_up) in the receiver, the settings in this
file can be applied immediately after the default application file,
overriding the factory defaults.
For more information, see Application Files, page 129.
18.1Default Settings
Table 18.1 lists the default settings for the Trimble R8 receiver, as
defined in the default application file.
Table 18.1 Default settings
Function Factory default
SV Enable All SVs enabled
General Controls: Elevation mask 13°
PDOP mask 7
RTK positioning mode Low Latency
Motion Kinematic
Serial Port 1: Baud rate 115,200
Format 8-None-1
Flow control None
Serial Port 2: Baud rate 115,200
Format 8-None-1
Flow control None