User's Manual
Table Of Contents
- Safety Information
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R8 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes Trimble R7 / Trimble R8
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
Trimble R7/R8 GPS Receiver User Guide 141
Software Utilities 16
Trimble R8 GPS Receiver Operation
160.1 Configuring the internal transceiver
Use the WinFlash Internal Transceiver Configuration dialog to configure
the Trimble R8 internal transceiver.
B
Tip – To view a list of all radio information, including the current
configuration, click Radio Info.
1. Select the Current Channel, which determines the radio
operating frequency.
2. Select the Wireless Mode, which determines the over-the-air
communications parameters. The following example shows a
rover setup:
To reduce battery consumption on your base receiver, set the
wireless mode as high as possible. For example, 9600 bps
consumes half the power of 4800 bps for the same data format
and time of operation.